Just heard from Ohio… As expected, because it actually happened in 2004,  weird stuff is going on in Ohio’s elections… The voting machine companies  went to democratic districts of metropolitan Cleveland and Columbus,  whose vote totals amount to 4,041,056 registered voters…. and installed mysterious software patches.

Solid Republican districts had no such visits.   These machines have been in place for months.  Why now?

Here is how voting fraud works.  One it has to be believable.  Two, it has to be subtle.  Three, it has to be untraceable.   Videos are available on how machines can be tampered with… Every video, including one by Princeton University, says beware of software patches being applied just before election.

Well, software patches are being applied just before the election.

Why not do it earlier?   Because of error.  If Romney was winning by 5 points in the polls, and you set the calculations too low, if Obama was head by 2 or 3, you would be to low.   If Obama is ahead by 5 pts, and you set to subtract 6 from Obama and give to Romney, you will have a very close election, to the wire, but with a 1% advantage for Romney….

In other words, you have to know the probable spread, before you tamper….  No doubt in 2008, the last minute wave for Obama still carried him in some districts over McCain, even though the machines were flawed.  No one ever bothered to check because the turnout for Obama was at records higher than the voting machine adjusters dreamed was possible….

Bottom line,   something very fishy is going on.    An early morning sample run on each machine can be done with both parties watching…   Fake 100 votes, and verify the total.  Then erase and begin anew if the machine adds votes exactly like it was programed.  One switched vote out of 1oo could throw the election…..

Good luck, Ohio…   Wear your guns to the polls…  lol..

Notes:  From the contract between Ohio Secretaries Office and the vendors in charge of machines….

(Right click on image for full view)